Precision-digital PD6200 User Manual download pdf (Page 19)

Model PD6200 Analog Input Rate/Totalizer Instruction Manual

Transmitter Supply Voltage Selection (P+, P-)

All meters, including models equipped with the 12/24 VDC power

option, are shipped from the factory configured to provide 24 VDC

power for the transmitter or sensor.

If the transmitter requires 5 or 10 VDC excitation, the internal jumper

J4 must be configured accordingly.

To access the voltage selection jumper:

1. Remove all the connectors.

2. Unscrew the back cover.

3. Slide the back cover about 1 inch.

4. Configure the J4 jumper, located behind the input signal connector,

for the desired excitation voltage as shown.

MAIN BOARD

INPUT

SIGNAL

5 V

10 V

24 V

J4 CONFIGURATION

Factory Default

P+

P-

mA+

COM

V+

Figure 5: Transmitter Supply Voltage Selection

Connections

All connections are made to removable screw terminal connectors

located at the rear of the meter.

Caution!

Use copper wire with 60°C or 60/75°C insulation

for all line voltage connections. Observe all safe-

ty regulations. Electrical wiring should be per-

formed in accordance with all applicable national,

state, and local codes to prevent damage to the

meter and ensure personnel safety.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 107 108

No comments

Precision-digital PD6200 User Manual Page 19