Precision-digital PD6200 User Manual download pdf (Page 82)

Model PD6200 Analog Input Rate/Totalizer Instruction Manual

Tare (tare)

The tare function zero’s out the display. In the case of scale weight, tare

is used to eliminate container weight and provide net weight readings.

There are two tare functions; Capture Tare and Reset Tare.

This function may only be used when Total (

total) is set to No (no).

0.0

lbs

0.2

lbs

0.2

lbs

Before tare

After capture tare

After reset tare

Internal Source Calibration (ICAL)

The meter is factory calibrated prior to ship-

ment to read in milliamps and volts depending

on the input selection. The calibration equip-

ment is certified to NIST standards.

The internal source allows the user to scale the meter without applying a

signal.

The use of calibrated signal sources is necessary to perform the internal

source calibration of the meter.

Check calibration of the meter at least every 12 months. Each input must

be recalibrated separately.

Notes:

1. If meter is in operation and it is intended to

accept only one input type (e.g. 4-20 mA),

recalibration of other input is not necessary.

2. Allow the meter to warm up for at least

15 minutes before performing the internal

source calibration procedure.

The Internal calibration menu is part of the Advanced Features menu.

1. Press and hold the Menu button for three seconds to access the

advanced features of the meter.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 107 108

No comments

Precision-digital PD6200 User Manual Page 82